| 输送带皮带接头长度及角度是如何算出来的？ |
| 添加时间：2019/12/3 14:33:33 浏览次数： |
| 输送带皮带接头长度及角度是如何算出来的？ How is the length and angle of belt joint calculated? 一、硫化橡胶输送皮带的长短通常取输送机网络带宽的一大半，但也充分考虑传动带的整体长短，标准是带越长传动带连接头长短越多长，也要考虑到线柱高，线层越大，皮带接头的长度越长，每层一步。螺纹层的张力小于EP200。剩下后两层螺纹，比EP200的大。还剩一层线。硫化接头长度还要考虑接头硫化机的接头长度，硫化机边缘要留十公分空间，防止边缘温度不够。冷粘输送带接头长度比硫化接头略长5cm左右。 I. the length of vulcanized rubber conveyor belt is usually half of the conveyor network bandwidth, but the overall length of the transmission belt is also fully considered. The standard is that the longer the belt is, the longer the transmission belt connector is, the higher the line column, the larger the line layer, the longer the belt connector is, and each step is taken. The tension of thread layer is less than ep200. The remaining two threads are larger than those of ep200. There is a layer of wire left. The length of vulcanized joint shall also consider the joint length of joint vulcanizer, and a space of 10cm shall be reserved at the edge of vulcanizer to prevent insufficient edge temperature. The joint length of cold adhesive conveyor belt is about 5cm longer than that of vulcanization joint. 二、输送带接头的角度一般取30度左右，实际操作中上拐，取带宽长度的25%左右的长度差距如带宽是1m取25cm的斜度即可。一般根据硫化机的角度朝左边斜，冷粘接无所谓。 2. The angle of the conveyor belt joint is generally about 30 degrees. In actual operation, turn up and take about 25% of the length of the belt. For example, if the belt width is 1 m, take a slope of 25 cm. Generally according to the angle of the vulcanizer to the left, cold bonding does not matter. |
| 上一页 PVG阻燃输送带在宽度方向上允许有5%的跑偏量 |
| 下一页 输送带在使用过程中主要与哪些部位发生摩擦？ |
Copyright © 技术支持：遨游网络