| 输送带在使用过程中主要与哪些部位发生摩擦？ |
| 添加时间：2019/11/25 14:53:52 浏览次数： |
| 1、机架与输送带的摩擦，输送带有时会由于输送机的制造、安装、使用等造成的缺陷，而产生跑偏，当跑偏过多时，输送带与托辊支架、机架接触而造成边胶磨损甚至使输送带翻边。 1. The friction between the frame and the conveyor belt will lead to the deviation due to the manufacturing, installation, use and other defects of the conveyor. When the deviation is too much, the edge rubber will be worn or even the conveyor belt will be flanged due to the contact between the conveyor belt and the roller bracket and the frame. 2、导料槽挡板与输送带的摩擦，挡板对输送带的磨损是一种特殊的磨损，如对挡板的设计方法改进并注意维护，这种磨损几乎可以防止。3、托辊与输送带的摩擦，输送带的下覆盖胶也要受到调心托辊以及前倾槽形托辊的磨擦，在槽形托辊到滚筒的过渡段和输送机弯曲的凸起处都有磨损产生。 2. The friction between the guide chute baffle and the conveyor belt, and the abrasion of the baffle to the conveyor belt is a special kind of abrasion. For example, the design method of the baffle is improved and attention is paid to maintenance, which can be almost prevented. 3. The friction between the idler and the conveyor belt, and the lower covering rubber of the conveyor belt are also subject to the friction of the centering idler and the forward inclined groove idler. There is wear in the transition section between the groove idler and the roller and the convex part of the conveyor bending. 4、清扫器与输送带的摩擦，清扫器对输送带造成的磨损通常是均匀的，但用较硬的钢板作为清扫板时，如果使用方法不当，也会将除污物以外的橡胶切削下来，当清扫器尖和输送带间异物进入时，还会在输送带全长上划出很深的伤痕。 4. For the friction between the cleaner and the conveyor belt, the wear caused by the cleaner to the conveyor belt is usually uniform, but when the harder steel plate is used as the cleaning plate, if the use method is improper, the rubber other than dirt will also be cut off. When the foreign matters enter between the cleaner tip and the conveyor belt, the deep scars will be marked on the whole length of the conveyor belt. |
| 上一页 输送带皮带接头长度及角度是如何算出来的？ |
| 下一页 输送带粘接方法 |
Copyright © 技术支持：遨游网络