| PVG阻燃输送带在宽度方向上允许有5%的跑偏量 |
| 添加时间：2019/12/14 14:50:07 浏览次数： |
| PVG阻燃输送带边缘磨损主要是输送带跑偏时带边与机架的摩擦磨损，输送带应该在托辊组的中心线上运行，但由于输送机的制造、安装、使用等造成的缺陷，输送带时常会偏离中心线发生跑偏。 The edge wear of PVG flame retardant conveyor belt is mainly the friction wear between the belt edge and the frame when the conveyor belt deviates. The conveyor belt should run on the center line of the idler group. However, due to the defects caused by the manufacture, installation and use of the conveyor, the conveyor belt often deviates from the center line. 通常，PVG阻燃输送带在宽度方向上允许有5%的跑偏量，当跑偏过多时，输送带与托辊支架、机架接触而造成边胶磨损，严重跑偏时，甚至会使输送带翻边，如滚筒的径向游螺丝钉头，清扫器挡块等凸起部位，或机架间隙过小，易引起输送带撕裂，覆盖胶局部剥离和划伤。 Generally, PVG flame-retardant conveyor belt is allowed to have 5% deviation in the width direction. When there is too much deviation, the conveyor belt will contact with idler bracket and frame, which will cause side glue abrasion. When there is serious deviation, even the conveyor belt will be flanged, such as the radial traveling screw head of the drum, cleaner block and other raised parts, or the gap between the frames is too small, which is easy to cause belt tearing, partial peeling of the covering glue and Scratch. |
| 上一页 阻燃输送带性能特征 |
| 下一页 输送带皮带接头长度及角度是如何算出来的？ |
Copyright © 技术支持：遨游网络